| 123456789101112131415161718192021222324252627282930313233343536373839 |
- U-Boot for Wandboard
- --------------------
- This file contains information for the port of U-Boot to the Wandboard.
- Wandboard is a development board that has three variants based on the following
- SoCs: mx6 quad, mx6 dual lite and mx6 solo.
- For more details about Wandboard, please refer to:
- http://www.wandboard.org/
- Building U-Boot for Wandboard
- -----------------------------
- To build U-Boot for the Wandboard:
- $ make wandboard_config
- $ make
- Flashing U-Boot into the SD card
- --------------------------------
- - After the 'make' command completes, the generated 'SPL' binary must be
- flashed into the SD card;
- $ sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync
- (Note - the SD card node may vary, so adjust this as needed).
- - Flash the u-boot.img image into the SD card:
- sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync
- - Insert the SD card into the slot located in the bottom of the board (same side
- as the mx6 processor)
- - Connect the serial cable to the host PC
- - Power up the board and U-Boot messages will appear in the serial console.
|
