| 1234567891011121314151617181920 |
- README on how reset time on OMAPs should be calculated
- CONFIG_OMAP_PLATFORM_RESET_TIME_MAX_USEC:
- Most OMAPs' provide a way to specify the time for
- which the reset should be held low while the voltages
- and Oscillator outputs stabilize.
- This time is mostly board and PMIC dependent. Hence the
- boards are expected to specify a pre-computed time
- using the above option, (the details on how to compute
- the value are given below) without which a default time
- as specified by CONFIG_DEFAULT_OMAP_RESET_TIME_MAX_USEC
- is used.
- The value for CONFIG_OMAP_PLATFORM_RESET_TIME_MAX_USEC
- can be computed using a summation of the below 3 parameters
- -1- Time taken by the Osciallator to stop and restart
- -2- PMIC OTP time
- -3- Voltage ramp time, which can be derived using the
- PMIC slew rate and value of voltage ramp needed.
|
